Threat Management Gateway 2010 Lab Setup

Microsoft Threat Management Gateway 2010 Lab

Microsoft Threat Management Gateway Lab Diagram

Microsoft Forefront Threat Management Gateway 2010

In my TMG 2010 Lab, I have the following networks setup. External – Leading out to the internet, Internal – leading out to my local network, DMZ1 – leading out to my DMZ or Perimeter Network and DMZ2 leading out to an additional DMZ or Perimter Network.

Located on the internal network is my Windows 2008 R2 Active Directory Domain Controller.

Disclaimer:
All the tutorials included on this site are performed in a lab environment to simulate a real world production scenario. As everything is done to provide the most accurate steps to date, we take no responsibility if you implement any of these steps in a production environment.

ram says:
October 25, 2013 at 23:21
I have my home Lab Windows 7 , in the top of windows 7 vmware workstation and vms tmg 2010, i have 1 nic card which is connected through wifi router with local isp internet, how to configure without static ip in TMG 2010?
Reply
- David Rodriguez says:
  October 28, 2013 at 07:15
  One side of your wifi router will be your internet address, the other side (your local lan) will be a static IP as this will be your default gateway on your lan. Set TMG up with a static IP on your local lan, and use your wifi router as the default gateway
  Reply