If you have been working with Netapp Clustered Data Ontap for a while now you would no doubt have performed quite a few volume moves. However one limitation of the volume move command was that you couldn’t move the volume between storage virtual machines (SVM’s)
The Cisco Nexus 9K’s have been out for a little while now, however it has only been recently that the support for FCoE have come to these switches.
If you are taking non-zeroed disks from a later version of Netapp Data Ontap and placing them into a system running an earlier version of Data Ontap you may experience the following warning, error and critical messages in the log:
There is an issue installing Netapp Performance Manager 2.1RC1 on VMware vSphere 5.5 where by the network settings do not get applied during the install wizard.
Last week Netapp released the latest Unified Manager and Performance manager. The latest release ties the 2 products closer than ever with the new Full Integration option (Single pane of glass), which allows you to view both Unified Manager health information and Performance Manager information within the same window.
There is currently a small issue when trying to upgrade from Netapp Unified Manager 6.3 RC1 to 6.3 GA, where by at the beginning of the upgrade the wizard cannot find the CDROM and displays:
I came across a few issues upgrading a site from vCenter 5.5 update 2 up to update 3b. I’m writing this article in the hope that if you run into the same problem it will save you hours of troubleshooting and support calls with VMware.
I have been trying out a few different configurations in my lab with a Netapp and Veeam setup running snapmirror and snapvault on the same volume.